Insuring Your Historic Building During Repairs and Alterations
Matthew Mullee
| As the fire at Windsor Castle showed, historic buildings are more at risk during building works than at any other time. Matthew Mullee of La Playa examines insurance issues for repair, alteration or extension work. | 
Whether or not you're considering restoration or alteration work, make sure you set yourself up with watertight insurance from the outset. If you own an historic building, whether it is a stately home or an ancient cottage, a standard policy from a general insurance provider could fall well short of expectations if you need to make a claim. If your building is also listed, it is protected by law, limiting repair options and making some higher costs unavoidable: it is the responsibility of the owner to insure it properly.
CHOOSING 
                A SUITABLE INSURANCE POLICY 
                
          It 
            does pay to use a specialist insurance broker who can provide advice about 
            the choice of insurer, negotiate better premium rates and cover, and will 
            usually arrange a 'risk management' appraisal. They will also think ahead 
            to issues which will come up if the property needs to be repaired, altered 
            or extended. 
Building value - the difference between 'market' value and 'reinstatement' value is crucial for historic buildings. You need to determine how much it would cost to rebuild the entire building using like materials and methods of construction. A cursory note of the exterior construction is really not sufficient to calculate the rebuilding cost: from the outside, a building may appear to date from the 18th century, but the inner timber structure may be 15th century. Special features could be overlooked, such as fireplace mantles, plaster mouldings, carved timber panelling. Insurers like Independent, Chubb and Hiscox provide specialist appraisers.
Cover for repairs - repair contracts of substantial historic buildings can be long and complicated, giving rise to many extra costs. The standard 'cost per square metre' tables used by non-specialist insurers and mortgage company surveyors to calculate rebuilding costs are simply not up to the job as far as historic buildings are concerned, especially if authentic materials are required. The Association of British Insurers advises that these tables are suitable only for houses of 'average quality finish' and that if a pre-1920 house needs be reinstated to its original style, a professional valuation is required.
| A 
                    CASE IN POINT A Georgian home in the Midlands was converted into seven units and insured under a standard policy for £7 million. Moving to a specialist insurer who conducted a risk management appraisal, the residents discovered that the cost of rebuilding the property would have been over £15 million. In the event of a fire, the residents could have suffered a financial loss of over £8m, which would NOT BE PAID by the insurer. The revised policy offered double the cover for only 25 per cent extra premium. | 
WHEN 
                YOU COME TO REPAIRS AND ALTERATIONS
          Having 
            decided on the new wing to be added to the property, or renovation project 
            to be undertaken, talk to your insurer about extending your cover for 
            the works. 
Some insurers reserve the right to refuse cover for works over £75,000, or where a JCT Minor Works 6.3b contract (the standard contract between builder and client) has not been signed. Others will happily re-insure if the paperwork is in place. For example, Chubb Insurance will ask you to complete a questionnaire providing details such as the name of the contractor, their insurers and the scope of their insurance policy (the amount of their public liability cover, and the limit of indemnity), as well as a full description of works to be carried out. They will also need to know the contract value, contract period, details of security at the site, fire protection during the works and whether a JCT Clause is applicable.
If the property is uninhabited during the works, extra theft cover may need to be put in place. If the property is open to the public, the owner's public liability cover will need reviewing, too.
WHO 
                DOES WHAT?
                
          The 
            parties involved in the building works will usually be co-ordinated by 
            an architect or surveyor who will oversee the project. They will tender 
            the work out to trusted building contractors and craftsmen. The choice 
            of contractors is important as specialist materials and skills may be 
            required to achieve a proper repair, and a poor job could affect the market 
            value of the property. If the work is part of an insurance claim, most 
            non-specialist insurers will insist that a building contractor from their 
            own panel is used, but insurers such as Independent, Chubb and Hiscox 
            allow their clients to use the most appropriate craftsmen for the repair 
            work.
| Who is liable for what? | |
| RISK | RESPONSIBILITY | 
| Existing Property | Owner | 
| Works in progress | Owner | 
| Negligent damage | Contractor's public liability | 
The 
                architect/surveyor will probably use the JCT Minor Works 6.3b contract 
                conditions to form the basis of the contract between you and the builder. 
                This usually places the onus on the owner as the employer to insure against 
                material damage to the project - hence the need to brief the insurance 
                company fully. You need an insurer and broker 
 who understand these contract 
                conditions.
This onus on the property owner is the subject of some debate among insurers, and may change in the future so that the contractor becomes responsible for the works' insurance.
The main contractor has a responsibility to ensure that no damage is caused to the property and must maintain adequate public liability insurance. The indemnity limit should reflect the maximum potential loss. For smaller homes an indemnity limit of £2 million will be adequate; for larger properties, the sum insured will need to be increased accordingly. Any sub-contractors who are employed must also carry the same indemnity limit and their insurance details should be verified before they start work.
Many claims arise from 'hot works'. Blowtorches and welding equipment for example, if left smouldering, may start a blaze and all naked flames have been banned from some historic properties. Where works are permissible all reputable contractors should have a hot works permit that requires them to monitor an area worked on for at least an hour after the work has been completed. Check that the contractor or any sub-contractor does not have a heat exclusion in their liability policy, as this will affect your insurer's recovery rights.
If the building being worked on is close to other people's property, the owner should consider extending the contractor's liability insurance to cover non-negligent damage that may be caused during the works; the JCT 21 2 1 contract.
EXPOSURES
                
                  Repair 
                    and alteration works will make your property particularly susceptible 
            to damage: 
Fire - risks 
                may be increased due to temporary wiring, exposed electrical wiring, electrical 
                shorts brought about by pulling wiring, or damage to wiring caused by 
                sloppy demolition of surrounding walls and ceilings. Flammable welding 
                gases and paint removal torches are also dangerous.
          Water - damaged pipes and exposure to the elements add to the risks.
          Mechanical 
            systems  - such as ventilation, heating, air conditioning and plumbing systems, 
              need special attention. Natural gas piping is a primary concern and often 
              gets damaged during renovation works.
          Roof - renovations pose increased risks from both water and fire damage. Water 
            damage claims are more common, but roof fires started by tar kettles, 
            welding and other hot works are not uncommon.
          Theft/vandalism - a work site may be exposed to theft, particularly of architectural items 
            such as fireplaces.
          Public 
            safety  - if your property is open to the public, holes, walkways and other obstructions 
            may be a hazard.
MINIMISING 
                THE RISK
                
          Good 
            risk management is vital. A specialist insurance policy will make allowance 
            for the costs of temporary shoring to prevent further collapse of the 
            building, and for the cost of protecting the property from the elements 
            and theft. Here are a few ways to reduce risk exposure:
Housekeeping - renovation 
                projects often generate a substantial amount of debris. This debris contributes 
                significantly to the flammable load contained within a building, so keep 
                it cleared with all debris removed from the site regularly.
          Electrics - faulty electrical wiring and appliances cause most fires. It is essential 
            that all wiring and older electrical appliances are certified safe by 
            a qualified electrician.
          Fire 
            protection  - extend into the site such fire protection measures as fire blankets 
              and fire extinguishers as well as panic buttons and smoke detectors linked 
              to a monitoring station. For larger homes, a visit from the local fire 
              officer should be arranged so that the brigade is familiar with the access 
              to your property, the layout and the nearest water supply. A smoking ban 
              should be mandatory on the site. If repairs are being undertaken on a 
              large scale, it may be worth installing a temporary sprinkler system.
          Water - ensure the property is inspected for weatherproofing at the end of each 
            working day. You could also install leak sensors on pipes, leak trays 
            under pipes in high risk areas, and/or automatic isolator valves.
          Theft/vandalism - scaffolding may make the building more accessible to intruders, so it 
            might be necessary to consider employing security staff.
          Security 
            measures should be carefully designed so as not to compromise or damage 
            the historic fabric or integrity of the building.
THE 
                COST OF INSURING YOUR REPAIR WORKS
                
          You 
            will need to allow for an extra charge for the extended cover during the 
            works. Once the works are completed (and your property's reinstatement 
            value has increased with a brand new wing or a magnificent face-lift) 
            the sum insured, and consequently the premium, will increase.
WORK 
                WITH SPECIALISTS
                
          Just 
            as it is necessary to employ specialist craftsmen to restore a moulding, 
            it really is worth choosing a specialist broker who can advise on cover 
            and deal with claims settlements and disaster recovery quickly and easily. 
            This will protect both the fabric and the value of your home - not to 
            mention your sanity - when it comes to the crunch.



